For the complete documentation index, see llms.txt. This page is also available as Markdown.

Employees

Add your team, invite them, and give them access to the right parts of Schedulink.

An employee is anyone at your studio who works in Schedulink: photographers, coordinators, editors, front desk, admins.

Getting someone set up takes three steps, and the order matters because you can't assign access until they've accepted their invite.

1. Decide what they should see

Before inviting anyone, make sure a permission set exists for the kind of work they do. A photographer needs a very different view from an office manager.

If you haven't built these yet, start with Permissions.

2. Add and invite them

Go to Setup > Employees. If the person doesn't exist yet, add their details. Then send them an invite, either from their row in the list or from their own page.

They'll get an email with a link to create their account.

Where everyone stands

The employee list shows a status against each person, so you can see at a glance who's actually in.

Status
What it means

Not invited

They exist in Schedulink but nothing has been sent

Invited

The email has gone and they haven't signed up yet

Invite expired

The link ran out before they used it. Send another

Active

They've signed up and can use Schedulink

Their own page carries a banner telling you what to do next, and you can send or resend from either place.

Every invite sent, resent or accepted is recorded in their activity log, along with the email address it went to. So if an invite went to a typo and you corrected it, both addresses are on record.

3. Assign their permissions

You can't do this until they're Active. Open their profile in Setup > Employees, find the User Permissions field, choose the set you want, and save.

The change applies immediately. They don't need to log out and back in.

This is the step most often missed. Adding someone and inviting them doesn't give them access on its own, so if a new starter says they can't see anything, check that a permission set was assigned.

When someone leaves

Archive them rather than deleting. Archiving keeps the record of what they worked on and takes them out of the lists your team picks from, so nobody gets assigned to a job by mistake.

They're still there if you need them. Use the archived toggle on the filter bar to the left of the employee list to see archived people, which is what you'll do if a seasonal photographer comes back next autumn.

Last updated

Was this helpful?